List of daily maintenance items of plastic processing equipment
For plastic processing equipment, daily maintenance is still very important, because it can effectively prevent equipment failure and properly maintain the plastic processing equipment. Therefore, I hope you can remember to do regular maintenance when you use the equipment, In this way, the subsequent use of plastic processing equipment can be carried out smoothly.
1、 Glue injection system
1. Adhere to external cleaning of cylinder core appearance, cylinder auxiliary column, material pipe Mada column, valve seat cylinder mandrel, etc., to prevent pollution from accumulating outside and hidden in cracks of plastic processing equipment components, affecting performance.
2. Regularly check the nuts of the system to ensure the normal operation of plastic processing equipment.
3. Take out some Machinable plastics from the threads every three months, because some threads should be coated with heat-resistant grease (red lead or molybdenum disulfide) at high temperature to avoid being worn to death.
4. Except for plastics, pigments and additives, other articles shall not be put into the products to damage the screws and additives.
5. When the plastic processing equipment does not reach the pre-regulated temperature, do not start the oil pressure motor drive, spray glue or loosen, otherwise the screw head will be damaged.
2、 Die locking and formwork
1. Strictly observe the external cleaning of mold barrel mandrel, mold barrel column and upper and lower columns to prevent the accumulation of dirt and avoid damaging these parts during the operation of plastic processing equipment.
2. Control the pressure, speed and position adjustment of split stroke, and reduce the impact to avoid damaging the formwork and die.
3. When closing each time, open the mold to make the gap between the upper and lower molds stick. If the mold is fully opened, the machine will be in working state because of the above template and some self weight due to the mold. Affect the service life of oil seal valve and other components.
4. The auxiliary die fixing screw can prevent the use of alloy screws with too high hardness. The depth of locking the screw of plastic processing equipment into the teeth must be greater than the corresponding depth, and the tightening torque must be appropriate. Before fixing the mold, remember to check whether the mold and fixed surface are clean, and wipe it if necessary.
The above is all about the plastic processing equipment we shared for you. I believe you have a deeper understanding of the equipment after reading this article. If you still have anything unclear, you can call us or leave a message directly at the station, and we will reply in time.
